Fastboot commands work only when your device is booted into the Fastboot or bootloader mode. It works as a communication bridge between your computer and Android device. Just like ADB ( Android Debug Bridge), Fastboot is a command-line tool as well as a protocol on Android devices. Flash Update.zip via Fastboot What is Fastboot? I'm thinking this isn't a full solution due to the following messages:Īnd the fact the device didn't boot to Linux. Windows also detected the device to be an "Android ADB Interface" when it booted via RAM. Finally I took a "simple" route and simply included the m圆sabreandroid_common header file which resided within include/configs as can be seen from the below patch file:Īfter doing this, the build finished successfully and I was able to access the "fastboot" command from the u-boot prompt. Thanks for your reply, I attempted to use the patch as you suggested but after applying it there were a number of additional build failures. How to use uuu -s to enter FB: ucmd commands to flash IMX6 ? emmc_burn_all.lst file to flash : u-boot.imx -> zImage -> im圆qd-nano.dtb -> fsl-image-gui-im圆qdnano.sdcardĢ. I'm new to the NXP IMX6 environment, kindly help with your inputs on :ġ. Run bootcmd_mfg: run mfgtool_args if test $ fi In u-boot I added the fastboot support, by using details at : īut now the u-boot command fastboot is giving the error : I'm facing the same issue of fastboot not identifying the deviceUSB_controller when flashing Yocto based Linux image. +#define CONFIG_G_DNL_MANUFACTURER "Freescale" +#define CONFIG_USB_FASTBOOT_BUF_SIZE 0x10000000 +#define CONFIG_USB_FASTBOOT_BUF_ADDR CONFIG_SYS_LOAD_ADDR
+#define CONFIG_EHCI_HCD_INIT_AFTER_RESET +#define CONFIG_MXC_USB_PORTSC (PORT_PTS_UTMI | PORT_PTS_PTW) #endif /* CONFIG_SPLASH_SCREEN & CONFIG_MXC_EPDC */
+++ -93,7 +93,7 defined(CONFIG_SPLASH_SCREEN) & defined(CONFIG_MXC_EPDC) Is there any information, wikis, or places where it's listed out what needs to be done to enable fastboot in the bootloader for the SABRE i.MX6Q board? I attempted to add the correct configuration options into the include/configs/m圆sabresd.h header file, but for some reason the built u-boot.imx still doesn't have the fastboot tool enabled. I've read on a few different sites, ex: Factory flashing with U-Boot and fastboot on Freescale i.MX6, that's it's possible to enable Fastboot in the u-boot bootloader for i.MX6 products.
0 kommentar(er)
